LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Frontier SL, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Transfer Case) >> Removal And Installation >> Transfer Control Unit >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Switch 4WD shift switch to 2WD and set transfer assembly to 2WD.
    CAUTION: When removing transfer control unit, transfer state must be at 2WD.
  2. Turn the ignition switch OFF and disconnect negative battery terminal.
  3. Remove the instrument lower panel LH. Refer to "REMOVAL AND INSTALLATION ".
  4. Disconnect the two transfer control unit connectors.
  5. Remove the transfer control unit bolts.
  6. Remove the transfer control unit.
Fig 1: Identifying Transfer Control Unit With Bolts
G04898489Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals