LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube S, Standard Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0605 To P2A00 (Except CALIFORNIA) >> DTC P2135: TP Sensor >> Component Inspection

Component Inspection

  1. CHECK THROTTLE POSITION SENSOR
    1. Turn ignition switch OFF.
    2. Reconnect all harness connectors disconnected.
    3. Perform "THROTTLE VALVE CLOSED POSITION LEARNING: Special Repair Requirement ".
    4. Turn ignition switch ON.
    5. Set selector lever to D (CVT) or 1st (M/T) position.
    6. Check the voltage between ECM harness connector and ground.
    ECM Ground Condition Voltage
    Connector Terminal
    F8 33 (TP sensor 1 signal) Ground Accelerator pedal Fully released More than 0.36V
    Fully depressed Less than 4.75V
    34 (TP sensor 2 signal) Fully released Less than 4.75V
    Fully depressed More than 0.36V

    Is the inspection result normal? 

    YES >> INSPECTION END

    NO >> GO TO 2.

  2. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
    1. Replace electric throttle control actuator.
    2. Perform "Special Repair Requirement ".

    >> INSPECTION END

scientia non olet · About LEMON Manuals