LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube S, Automatic CVT Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0137 To P0445 (CALIFORNIA) >> DTC P0327, P0328: KS >> Component Inspection

Component Inspection

  1. CHECK KNOCK SENSOR
    1. Turn ignition switch OFF.
    2. Disconnect knock sensor harness connector.
    3. Check resistance between knock sensor terminals as per the following.
      NOTE: It is necessary to use an ohmmeter which can measure more than 10 MΩ.
      Terminals Resistance
      1 and 2 Approx. 532 - 588 kΩ [at 20°C (68°F)]
      CAUTION: Do not use any knock sensors that have been dropped or physically damaged. Use only new ones.

      Is the inspection result normal? 

      YES >> INSPECTION END

      NO >> Replace knock sensor. Refer to "EXPLODED VIEW ".

scientia non olet · About LEMON Manuals