Front Coil Spring And Strut: Disposal

Set strut assembly horizontally to the ground with the piston rod fully extracted.
Drill 2 - 3 mm (0.08 - 0.12 in) hole at the position (• ) from top as shown in the figure to release gas gradually.
CAUTION:
- Wear eye protection (safety glasses).
- Wear gloves.
- Be careful with metal chips or oil blown out by the compressed gas.
NOTE:
- Drill vertically in this direction (<=).
- Directly to the outer tube avoiding brackets.
- The gas is clear, colorless, odorless, and harmless.
A: 20 - 30 mm (0.79 - 1.18 in)

Fig 1: Identifying Drill Hole At Position From Top
Courtesy of NISSAN NORTH AMERICA, INC.
Position the drilled hole downward and drain oil by moving the piston rod several times.
CAUTION: Dispose of drained oil according to the law and local regulations.