Slide motor, Front up-down motor. Rear up-down motor

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ), and precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or servicing.

Remove the driver's seat (see FRONT SEAT REMOVAL/INSTALLATION ).
Disconnect the 2P connector from each power seat motor.
NOTE: All connectors are terminal side of male terminals.

Fig 1: Identifying Driver's Power Seat Motor Connector Terminals
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Test each motor by connecting power and ground according to the table. When the motor stops running, disconnect battery power immediately.

Fig 2: Slide Motor Continuity Reference Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 3: Front Up-Down Motor Continuity Reference Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 4: Rear Up-Down Motor Continuity Reference Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the front up-down motor or rear up-down motor does not run or fails to run smoothly, replace the faulty motor (see FRONT SEAT LINKAGE DISASSEMBLY/REASSEMBLY ).

If the slide motor does not run or fails to run smoothly, replace the left seat track/slide motor (see FRONT SEAT LINKAGE DISASSEMBLY/REASSEMBLY ).

NOTE: The slide motor is not available separately because it is assembled into the left seat track, refer to the seat linkage disassembly/reassembly (see FRONT SEAT LINKAGE DISASSEMBLY/REASSEMBLY ).