LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> 370Z Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Registration >> Transmitter Wake-Up Operation

Transmitter Wake-Up Operation

NOTE: New replacement transmitters are provided "asleep" and must first be "woken up" using Transmitter Activation Tool J-45295 or Signal Tech II Tool J-50190 before ID registration can be performed. Use the following procedure when using the Transmitter Activation Tool J-45295.
  1. With the ignition switch in OFF position, connect scan tool to the Data Link Connector (DLC). Turn ignition switch to ON position.
  2. Display "WORK SUPPORT" screen, and select "ID REGIST".
  3. With the Transmitter Activation Tool (J-45295) pushed against the left front tire air-valve, press the button for 5 seconds. See Figure. Sensor activation must be performed in the order listed: Left Front, Right Front, Right Rear, Left Rear

    As each sensor ID is activated, the TPMS warning light flashes in the pattern shown in TPMS Warning Light Blink Patterns  table, and the activation tool LED changes from red to green.

    TPMS Warning Light Blink Patterns

    Wheel Location Number Of Warning Indicator Blinks
    Left Front 1 Blink
    Right Front 2 Blinks
    Right Rear 3 Blinks
    Left Rear 4 Blinks
    All Tires 1 Long (2 sec.) Blink
  4. Check that the turn signal lights blink twice when the transmitter wake-up procedure for all wheels is completed.
  5. After completing wake up of all transmitters, make sure TPMS warning light goes out.
scientia non olet · About LEMON Manuals