Service Information: Precautions: Precaution

NOTE: If any malfunction occurs in the RE0F08B model transaxle, replace the entire transaxle assembly.

Before connecting or disconnecting the TCM harness connector, turn ignition switch OFF and disconnect negative battery cable. Because battery voltage is applied to TCM even if ignition switch is turned OFF.

Fig 1: Disconnecting Negative Battery Cable
Courtesy of NISSAN MOTOR CO., U.S.A.
When connecting or disconnecting pin connectors into or from TCM, take care not to damage pin terminals (bend or break).
When connecting pin connectors make sure that there are not any bends or breaks on TCM pin terminal.

Fig 2: Checking TCM Pin Terminals (Bend Or Break)
Courtesy of NISSAN MOTOR CO., U.S.A.
Before replacing TCM, perform TCM input/output signal inspection and make sure whether TCM functions properly or not. "TCM TERMINAL AND REFERENCE VALUE ".

Fig 3: Precaution Before Replacing TCM
Courtesy of NISSAN MOTOR CO., U.S.A.
After performing each TROUBLE DIAGNOSIS, perform "DTC Confirmation Procedure".
If the repair is completed the DTC should not be displayed in the "DTC Confirmation Procedure".
Always use the specified brand of CVT fluid. Refer to "FLUIDS AND LUBRICANTS ".
Use lint-free paper, not cloth rags, during work.
After replacing the CVT fluid, dispose of the waste oil using the methods prescribed by law, ordinance, etc.

Fig 4: Identifying Malfunction Indicator Lamp

Courtesy of NISSAN MOTOR CO., U.S.A.