Removal and Installation: Removal

Refer to the figure for key interlock cable removal procedure.

1. Place the selector lever in the "N" position.
2. Remove the center console assembly. Refer to ON-VEHICLE REPAIR .
3. Slide the slider (A) toward the casing cap (B) while pressing tabs (C) on the slider to separate the slider (A) from the adjust holder (D).
4. Remove the casing cap (B) from the cable bracket on the CVT shift selector assembly.
5. Remove the key interlock cable from the key interlock rod (E).
   Fig 1: Locating Casing Cap And CVT Shift Selector Assembly

   Courtesy of NISSAN MOTOR CO., U.S.A.
6. Remove steering column cover (upper and lower) and instrument lower finisher. Refer to ON-VEHICLE REPAIR .
7. Pull out the lock plate (A) from the holder (B).
8. Remove the key interlock cable (1) from the key cylinder (2).
   Fig 2: Locating Lock Plate And Holder

   Courtesy of NISSAN MOTOR CO., U.S.A.
9. Remove the clip (A), and then remove the key interlock cable (1).
   Fig 3: Locating Key Interlock Cable And Clip

   Courtesy of NISSAN MOTOR CO., U.S.A.