LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2011 >> Versa Base, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Transaxle >> Service Information >> Key Interlock Cable >> Removal and Installation >> Installation

Removal and Installation: Installation

CAUTION:
  • Install key interlock cable in such a way that it will not be damaged by sharp bends, twists or interference with adjacent parts.
  • After installing key interlock cable to A/T shift selector assembly, make sure that casing cap and bracket are firmly secured in their positions.
  1. Place the selector lever in the "P" position.
  2. Turn ignition switch to "ACC" or "ON" position.
  3. Set the key interlock cable (1) to the key cylinder (2).
  4. Install the lock plate (A) to the holder (B).
  5. Turn ignition switch to "LOCK" position.
    Fig 1: Identifying Lock Plate And Holder
    G04927111Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Temporarily install the adjust holder (A) to the key interlock rod (B).
  7. Install the casing cap (C) to the cable bracket (D) on the A/T shift selector assembly.
    CAUTION:
    • Do not bend or twist key interlock cable excessively when installing.
    • After installing key interlock cable to cable bracket (D) on A/T shift selector assembly, make sure casing cap (C) is firmly secured in cable bracket (D) on A/T shift selector assembly.
    • If casing cap (C) is loose [less than 39.2 N (4.0 kg, 8.8 lb) removing force], replace key interlock cable.
      Fig 2: Identifying Adjust Holder And Key Interlock Rod
      G04927113Courtesy of NISSAN MOTOR CO., U.S.A.
  8. Slide the slider (A) toward the key interlock rod (D) while pressing the pull lock (B) down to securely connect the adjust holder (C) with the key interlock rod (D).
    CAUTION:
    • Do not press tabs when holding slider (A).
    • Do not apply any side to side force to key interlock rod (D) when sliding slider (A).
      Fig 3: Identifying Key Interlock Rod, Lock And Slider
      G05915083Courtesy of NISSAN MOTOR CO., U.S.A.
  9. Secure the key interlock cable (1) with the clip (A).
  10. Install steering column cover (upper and lower) and instrument lower finisher. Refer to ON-VEHICLE REPAIR .
  11. Install the center console assembly. Refer to ON-VEHICLE REPAIR .
  12. Install the selector lever handle. Refer to "SELECTOR LEVER HANDLE REMOVAL AND INSTALLATION ".
  13. Check shift lock system. Refer to "DESCRIPTION ".
    Fig 4: Identifying Key Interlock Cable And Clip
    G06538593Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals