LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2011 >> Versa Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (CVT) >> Service Information >> Key Interlock Cable >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Install key interlock cable in such a way that it will not be damaged by sharp bends, twists or interference with adjacent parts.
  • After installing key interlock cable to CVT shift selector assembly, make sure that casing cap and bracket are firmly secured in their positions.
  1. Place the selector lever in the "P" position.
  2. Turn ignition switch to "ACC" or "ON" position.
  3. Set the key interlock cable (1) to the key cylinder (2).
  4. Install the lock plate (A) to the holder (B).
  5. Turn ignition switch to "LOCK" position.
    Fig 1: Locating Key Interlock Cable And Key Cylinder
    G04927111Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Temporarily install the adjust holder (A) to the key interlock rod (B).
  7. Install the casing cap (C) to the cable bracket (D) on the CVT shift selector assembly.
    CAUTION:
    • Do not bend or twist key interlock cable excessively when installing.
    • After installing key interlock cable to cable bracket (D) on CVT shift selector assembly, make sure casing caps (C) is firmly secured in cable bracket (D) on CVT shift selector assembly.
    • If casing cap (C) is loose [less than 39.2 N (4.0 kg, 8.8 lb) removing force], replace key interlock cable.
    Fig 2: Locating Cable Bracket And CVT Shift Selector Assembly
    G04927113Courtesy of NISSAN MOTOR CO., U.S.A.
  8. Slide the slider (A) toward the key interlock rod (D) while pressing the pull lock (B) down to securely connect the adjust holder (C) with the key interlock rod (D).
    CAUTION:
    • Do not press tabs when holding slider (A).
    • Do not apply any side to side force to key interlock rod (D) when sliding slider (A).
    Fig 3: Locating Key Interlock Rod
    G05915083Courtesy of NISSAN MOTOR CO., U.S.A.
  9. Secure the key interlock cable (1) with the clip (A).
  10. Install steering column cover (upper and lower) and instrument lower finisher. Refer to ON-VEHICLE REPAIR .
  11. Install the center console assembly. Refer to ON-VEHICLE REPAIR .
  12. Install the selector lever handle. Refer to "SELECTOR LEVER HANDLE REMOVAL AND INSTALLATION ".
  13. Check shift lock system. Refer to "DESCRIPTION ".
    Fig 4: Locating Key Interlock Cable And Clip
    G06538593Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals