CVT CONTROL SYSTEM : Fail-safe: Description

When a malfunction is detected in each sensor, switch, solenoid or others, this function provides control to minimize reduction of driveability so that durability of transmission assembly can be acquired.

DTC CHART

DTC	Condition	Vehicle behavior
P0703	-	Start is slow Acceleration is slow
P0705	-	Position indicator on combination meter is not displayed Selector shock is large Start is slow Acceleration at high load state is slow Manual mode is not activated Lock-up is not performed
P0710	Engine coolant temperature when engine starts is 10°C (50°F) or more	Start is slow
	Engine coolant temperature when engine starts is 10°C (50°F) or less	Start is slow Acceleration is slow Vehicle speed is not increased
	Engine coolant temperature when engine starts is -35°C (-31°F) or less	Vehicle speed is not increased
P0715	-	Acceleration is slow Re-start is slow after vehicle is stop by strong deceleration Manual mode is not activated Lock-up is not performed
P0720	-	Start is slow Acceleration is slow Re-start is slow after vehicle is stop by strong deceleration Manual mode is not activated Lock-up is not performed
P0725	-	Lock-up is not performed
P0740	-	Selector shock is large Lock-up is not performed
P0744	-	Lock-up is not performed
P0746	A malfunction is detected	Start is slow Acceleration is slow Lock-up is not performed
P0746	Function is excessively reduced after a malfunction is detected	Start is difficult Drive is difficult Lock-up is not performed
P0778	-	Vehicle speed is not increased
P0826	-	Manual mode is not activated
P0840	-	Start is slow Acceleration is slow
P0841	-	Start is slow Acceleration is slow
P0845	-	Start is slow Acceleration is slow
P0868	-	Start is slow Acceleration is slow
P1701	-	Start is slow Acceleration is slow
P1705	-	Acceleration is slow Lock-up is not performed
P1722	-	Lock-up is not activated in coast state
P1723	A malfunction is detected in primary pulley speed sensor side	Acceleration is slow Re-start is slow after vehicle is stop by strong deceleration Manual mode is not activated Lock-up is not performed
P1723	A malfunction is detected in secondary pulley speed sensor	Start is slow Acceleration is slow Re-start is slow after vehicle is stop by strong deceleration Manual mode is not activated Lock-up is not performed
P1726	-	Acceleration is slow
P1740	-	Selector shock is large Lock-up is not performed
P1777	A malfunction is detected in low side (when vehicle is stopped)	Vehicle speed is not increased Lock-up is not performed
P1777	A malfunction is detected in high side (during driving)	Start is slow Acceleration is slow Lock-up is not performed
U1000	-	Start is slow Acceleration is slow Vehicle speed is not increased
U1010	-	Start is slow Acceleration is slow Vehicle speed is not increased