Component Inspection

CHECK CAMSHAFT POSITION SENSOR (PHASE)-I
1. Turn ignition switch OFF.
2. Loosen the fixing bolt of the sensor.
3. Disconnect camshaft position sensor (PHASE) harness connector.
4. Remove the sensor. Refer to "EXPLODED VIEW ".
5. Visually check the sensor for chipping.
  Is the inspection result normal?
  
  YES: Go to 2.
  
  NO: Replace camshaft position sensor (PHASE). Refer to "EXPLODED VIEW ".
  
  Fig 1: Checking Camshaft Position Sensor (Phase)-I
  Courtesy of NISSAN MOTOR CO., U.S.A.

CHECK CAMSHAFT POSITION SENSOR (PHASE)-II

Check resistance camshaft position sensor (PHASE) terminals as per the following.

RESISTANCE REFERENCE CHART

Terminals (Polarity)	Resistance [Ω at 25°C (77°F)]
1 (+) - 2 (-)	Except 0 or ∞
1 (+) - 3 (-)
2 (+) - 3 (-)

Is the inspection result normal?

YES: INSPECTION END

NO: Replace camshaft position sensor (PHASE). Refer to "EXPLODED VIEW ".