LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2011 >> Altima SL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 73 (Hybrid Control System - Component Testing) >> Unit Removal And Installation >> Sub Radiator >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION: Do not damage or scratch the radiator and condenser assembly and sub radiator core when removing.
  1. Drain the coolant from the inverter cooling system. Refer to "REPLACEMENT ".
  2. Remove the front air duct. Refer to "REMOVAL AND INSTALLATION ".
  3. Remove the front grille. Refer to "REMOVAL AND INSTALLATION ".
  4. Disconnect the high-pressure flexible hose and the high-pressure pipe from the condenser. Refer to "COMPONENT ".
  5. Disconnect the clamp (A) and the upper outlet hose (1) from the sub radiator (2).
    Fig 1: Identifying Clamp, Upper Outlet Hose And Sub Radiator
    G05912635Courtesy of NISSAN MOTOR CO.
  6. Disconnect the clamp (A) and the lower inlet hose (1) from the sub radiator (2).
    Fig 2: Identifying Clamp, Lower Inlet Hose And Sub Radiator
    G05030495Courtesy of NISSAN MOTOR CO.
  7. Disconnect the refrigerant pressure sensor electrical connector.
  8. Remove the bolts (A), then remove the sub radiator (1) from the vehicle.
Fig 3: Identifying Sub Radiator And Bolts
G05030496Courtesy of NISSAN MOTOR CO.
scientia non olet · About LEMON Manuals