ECM RE-COMMUNICATING FUNCTION : Description

WARNING: This page is about a different variant/trim than selected.

Performing following procedure can automatically perform re-communication of ECM and BCM, but only when the ECM has been replaced with a new one (*1).

*1: New one means an ECM which has never been energized on-board.

(In this step, initialization procedure by CONSULT-III is not necessary)

NOTE:

When registering new Key IDs or replacing the ECM that is not brand new, refer to CONSULT-III Operation Instructions NATS-IVIS/NVIS.
If multiple keys are attached to the key holder, separate them before work.
Distinguish keys with unregistered key ID from those with registered ID.