CVT Selector Lever (Park Position Switch) Check

1. Turn ignition switch OFF.
2. Check for continuity between Intelligent Key unit harness connector M42 terminal 10 and ground.
   CONTINUITY CHART
   
   

   Connector	Terminals		Condition	Continuity
   	(+)	(-)
   M42	10	Ground	Selector lever is in "P" position	Yes
   			Other than above	No

   Fig 1: Checking Continuity Between Intelligent Key Unit Harness Connector M42 Terminal 10 And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

   OK or NG 

   OK: Replace Intelligent Key unit. Refer to "REMOVAL AND INSTALLATION OF INTELLIGENT KEY UNIT ".

   NG: GO TO 2.

1. Disconnect CVT selector lever (park position switch) connector.
2. Check for continuity between CVT selector lever (park position switch) harness connector M38 terminal 2 and ground.

   2 - Ground : Continuity should exist. 

   Fig 2: Checking Continuity Between CVT Selector Lever (Park Position Switch) Harness Connector M38 Terminal 2 And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

   OK or NG 

   OK: GO TO 3.

   NG: Repair or replace harness.

Check continuity between CVT selector lever (park position switch) terminals 2 and 5.

OK or NG 

OK: Repair or replace harness.

NG: Replace CVT selector lever (park position switch).

Fig 3: Checking Continuity Between CVT Selector Lever (Park Position Switch) Terminals 2 And 5

Courtesy of NISSAN MOTOR CO., U.S.A.