LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2010 >> Maxima SV >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P1217 To P2A03 >> DTC P2135: TP Sensor >> Component Inspection

Component Inspection

  1. CHECK THROTTLE POSITION SENSOR
    1. Turn ignition switch OFF.
    2. Reconnect all harness connectors disconnected.
    3. Perform "SPECIAL REPAIR REQUIREMENT ".
    4. Turn ignition switch ON.
    5. Set selector lever to D position.
    6. Check the voltage between ECM harness connector terminals under the following conditions.
      CONNECTOR TERMINAL VOLTAGE CHART

      ECM Condition Voltage
      Connector + -
      Terminal Terminal
      F13 37 (TP sensor 1 signal) 36 (Sensor ground) Accelerator pedal Fully released More than 0.36 V
      Fully depressed Less than 4.75 V
      38 (TP sensor 2 signal) Fully released Less than 4.75 V
      Fully depressed More than 0.36 V
      Fig 1: Checking Voltage Between ECM Harness Connector Terminals
      G05869755Courtesy of NISSAN MOTOR CO., U.S.A.

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: GO TO  2.

  2. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
    1. Replace electric throttle control actuator.
    2. Go to "SPECIAL REPAIR REQUIREMENT ".

      INSPECTION END

scientia non olet · About LEMON Manuals