LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2010 >> Cube Krom >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0181 To P0607 >> P0327, P0328 KS >> Component Inspection

Component Inspection

  1. CHECK KNOCK SENSOR
    1. Turn ignition switch OFF.
    2. Disconnect knock sensor harness connector.
    3. Check resistance between knock sensor terminals as per the following.
    NOTE: It is necessary to use an ohmmeter which can measure more than 10 MΩ.
    RESISTANCE SPECIFICATION

    Terminals Resistance
    1 and 2 Approx. 532 - 588 kΩ [at 20°C (68°F)]
    CAUTION: Do not use any knock sensors that have been dropped or physically damaged. Use only new ones.

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: Replace knock sensor.

scientia non olet · About LEMON Manuals