LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2009 >> Versa Base, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Transmission >> Key Interlock Cable >> Removal and Installation >> Installation

Removal and Installation: Installation

CAUTION:
  • Install key interlock cable in such a way that it will not be damaged by sharp bends, twists or interference with adjacent parts.
  • After installing key interlock cable to control device assembly, make sure that casing cap and bracket are firmly secured in their positions.
  1. Place the selector lever in the "P" position.
  2. Turn ignition switch to "ACC" or "ON" position.
  3. Set the key interlock cable (1) to the key cylinder (2).
  4. Install the lock plate (A) to the holder (B).
  5. Turn ignition switch to "LOCK" position.
    Fig 1: Identifying Key Interlock Cable From Key Cylinder
    G04813189Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Temporarily install the adjust holder (A) to the key interlock rod (B).
  7. Install the casing cap (C) to the cable bracket (D) on the control device assembly.
    CAUTION:
    • Do not bend or twist key interlock cable excessively when installing.
    • After installing key interlock cable to cable bracket (D) on control device assembly, make sure casing cap (C) is firmly secured in cable bracket (D) on control device assembly.
    • If casing cap (C) is loose [less than 39.2 N (4.0 kg, 8.8 lb) removing force], replace key interlock cable.
      Fig 2: Locating Casing Cap To Cable Bracket On Control Device Assembly
      G04813192Courtesy of NISSAN MOTOR CO., U.S.A.
  8. Slide the slider (A) toward the key interlock rod (D) while pressing the pull lock (B) down to securely connect the adjust holder (C) with the key interlock rod (D).
    CAUTION:
    • Do not press tabs when holding slider (A).
    • Do not apply any side to side force to key interlock rod (D) when sliding slider (A).
      Fig 3: Identifying Key Interlock Rod, Adjust Holder And Lock
      G04813193Courtesy of NISSAN MOTOR CO., U.S.A.
  9. Secure the key interlock cable (1) with the clip (A).
    10. Fig 4: Identifying Key Interlock Cable And Clip
    G04813190Courtesy of NISSAN MOTOR CO., U.S.A.
  10. Install steering column cover (upper and lower) and instrument lower finisher. Refer to "INSTRUMENT PANEL ASSEMBLY ".
  11. Install the center console assembly. Refer to "INSTRUMENT PANEL ASSEMBLY ".
  12. Install the selector lever knob. Refer to "SELECTOR LEVER KNOB REMOVAL AND INSTALLATION ".
  13. Check shift lock system. Refer to "DESCRIPTION ".
scientia non olet · About LEMON Manuals