Removal and Installation: Installation

Installation is in the reverse order of removal.

• Tighten the nuts and bolts to the specified torque. Refer to "REMOVAL AND INSTALLATION ".
  NOTE: Do not reuse non-reusable parts.
• When installing steering column to steering member, install nut from front side of vehicle.
  CAUTION: When installing the steering column, finger-tighten all of the lower bracket and joint retaining bolts; then tighten them to specification. Do not apply undue stress to the steering column.
  NOTE: Align slit of the coupling joint with projection on dust cover. Insert the joint until surface A contacts surface B.
  Fig 1: Aligning Slit Of Coupling Joint With Projection On Dust Cover

  Courtesy of NISSAN MOTOR CO., U.S.A.
• After installation, turn steering wheel to make sure it moves smoothly. Ensure the number of turns are the same from the straight-forward position to left and right locks. Be sure that the steering wheel is in a neutral position when driving straight ahead.