Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect push-button ignition switch connector.
3. Check voltage between push-button ignition switch harness connector and ground.
   TERMINALS VOLTAGE REFERENCE
   
   

   (+)		(-)	Voltage (V) (Approx.)
   Push-button ignition switch
   Connector	Terminal
   M101	8	Ground	Battery voltage

   Is the inspection result normal? 

   YES: GO TO 2.

   NO: Check the following.

   • 10A fuse [No.9, located in fuse block (J/B)]
   • Harness for open or short between push-button ignition switch and fuse

1. Disconnect BCM connector and push button ignition switch connector.
2. Check continuity between BCM harness connector and push-button ignition switch harness connector.
   TERMINALS CONTINUITY REFERENCE
   
   

   Indicator	BCM		Push-button ignition switch		Continuity
   	Connector	Terminal	Connector	Terminal
   ACC/ON position	M119	15	M101	6	Existed
   	M122	93

3. Check continuity between BCM harness connector and ground.
   TERMINALS CONTINUITY REFERENCE
   
   

   Indicator	BCM		Ground	Continuity
   	Connector	Terminal
   ACC/ON position	M119	15		Not existed
   	M122	93

   Is the inspection result normal? 

   YES: GO TO 3.

   NO: Repair or replace harness or connector.

Refer to "COMPONENT INSPECTION ".

Is the inspection result normal? 

YES: GO TO 4.

NO: Replace push-button ignition switch. Refer to "REMOVAL AND INSTALLATION ".

Refer to "INTERMITTENT INCIDENT ".

INSPECTION END