Component Inspection

CHECK THROTTLE POSITION SENSOR

Turn ignition switch OFF.
Reconnect all harness connectors disconnected.
Perform "THROTTLE VALVE CLOSED POSITION LEARNING : SPECIAL REPAIR REQUIREMENT ".
Turn ignition switch ON.
Set selector lever to D (CVT) or 1st (M/T) position.
Check the voltage between ECM harness connector and ground.

VOLTAGE SPECIFICATION

ECM		Ground	Condition		Voltage
Connector	Terminal	Ground	Condition		Voltage
F8	33 (TP sensor 1 signal)	Ground	Accelerator pedal	Fully released	More than 0.36 V
	33 (TP sensor 1 signal)			Fully depressed	Less than 4.75 V
	34 (TP sensor 2 signal)			Fully released	Less than 4.75 V
	34 (TP sensor 2 signal)			Fully depressed	More than 0.36 V

Is the inspection result normal?

YES: INSPECTION END

NO: GO TO 2.

REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
1. Replace electric throttle control actuator.
2. Perform "SPECIAL REPAIR REQUIREMENT ".
INSPECTION END