LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2009 >> 350Z Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0441 To P0605 >> DTC P0452 EVAP Control System Pressure Sensor >> DTC Confirmation Procedure >> With GST

With GST

  1. Start engine and warm it up to normal operating temperature.
  2. Check that voltage between ECM terminal 106 (Fuel tank temperature sensor signal) and ground is less than 4.2V.
  3. Turn ignition switch OFF and wait at least 10 seconds.
  4. Start engine and wait at least 20 seconds.
  5. Select Service $07 with GST.

    If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".

    Fig 1: Checking Voltage Between ECM Terminal 106 And Ground
    G04875261Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals