Section 4 (Manual Transmission): RS6F94R: Precautions: Precautions

WARNING: This page is about a different variant/trim than selected.

If transaxle assembly is removed from the vehicle, always replace CSC (Concentric Slave Cylinder). Installed CSC returns to the original position when removing transaxle assembly. Dust on clutch disc sliding parts may damage CSC seal, and may cause clutch fluid leakage.
Do not reuse transaxle oil.
Drain, fill and check transaxle oil with the vehicle on level surface.
During removal or installation, keep inside of transaxle clear of dust or dirt.
Check for the correct installation orientation prior to removal or disassembly. If matching marks are required, be certain they do not interfere with the function of the parts they are applied to.
In principle, tighten bolts or nuts gradually in several steps working diagonally from inside to outside. If tightening sequence is specified, follow it.
Be careful not to damage the sliding surfaces and mating surfaces of parts.