Commercial Service Tools

WARNING: This page is about a different variant/trim than selected.

COMMERCIAL SERVICE TOOLS SPECIFICATIONS

(Kent-Moore No.) Tool name		Description
(BT-3373-F) Belt tension gauge	Courtesy of NISSAN MOTOR CO., U.S.A.	Checking drive belt tension
Power tool	Courtesy of NISSAN MOTOR CO., U.S.A.	Loosening bolts and nuts
Spark plug wrench	Courtesy of NISSAN MOTOR CO., U.S.A.	Removing and installing spark plug
Valve seat cutter set	Courtesy of NISSAN MOTOR CO., U.S.A.	Finishing valve seat dimensions
Piston ring expander	Courtesy of NISSAN MOTOR CO., U.S.A.	Removing and installing piston ring
KV10109300 ( - ) Pulley holder	Courtesy of NISSAN MOTOR CO., U.S.A.	Removing and installing crankshaft pulley
KV10111800 Valve guide drift	Courtesy of NISSAN MOTOR CO., U.S.A.	Removing and installing valve guide
Valve guide reamer	Courtesy of NISSAN MOTOR CO., U.S.A.	Reaming valve guide inner hole Reaming hole for oversize valve guide
(J-43897-18) (J-43897-12) Oxygen sensor thread cleaner	Courtesy of NISSAN MOTOR CO., U.S.A.	Reconditioning the exhaust system threads before installing a new oxygen sensor and Air Fuel ratio sensor (Use with anti-seize lubricant shown below.) a: J-43897-18 (18 mm dia.) Air Fuel ratio sensors b: J-43897-12 (12 mm dia.) Air Fuel ratio sensors
Anti-seize lubricant (Permatex 133AR or equivalent meeting MIL specification MIL-A-907)	Courtesy of NISSAN MOTOR CO., U.S.A.	Lubricating oxygen sensor thread cleaning tool when reconditioning exhaust system threads
E20 Torx® Socket (J-45816)	Courtesy of NISSAN MOTOR CO., U.S.A.	Removing and installing drive plate and flywheel bolts