LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Front Axle) >> Front Drive Shaft >> Disassembly and Assembly (Left Side) >> Disassembly >> Transaxle Side

Transaxle Side

WARNING: This page is about a different car, the 2007 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Mount drive shaft in a vise.
    CAUTION: When mounting shaft in a vise, always use copper or aluminum plates between vise and shaft.
  2. Remove boot bands and slide the boot back.
  3. Remove circlip and dust shield from slide joint housing.
  4. Put matching marks on slide joint housing and shaft, then pull out shaft from slide joint housing.
  5. Put matching marks on spider assembly and shaft.
    Fig 1: Identifying Matching Marks On Slide Joint Housing And Shaft
    G04889261
  6. Remove snap ring using a suitable tool, then remove spider assembly from shaft.
  7. Remove boot from shaft.
  8. Clean the old grease off of the slide joint assembly.
    Fig 2: Removing Snap Ring
    G04889262
scientia non olet · About LEMON Manuals