LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Power Steering System) >> Power Steering Gear And Linkage >> Disassembly and Assembly >> Assembly

Disassembly and Assembly: Assembly

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the inner sockets.
  2. Install the large-diameter side of the boots to the gear housing assembly.
  3. Install the small-diameter side of the boots to the groove of the inner sockets.
    Fig 1: Identifying Boot Clamp To Large And Small-Diameter Side Of Boot
    G04876909
  4. Install the boot clamps to the boots, as shown.
    CAUTION: Do not reuse the large boot clamps.
    Fig 2: Installing Boot Clamps To Boots
    G04902323
  5. Crimp the large boot clamps, using Tool.

    Tool number : KV40107300 ( - ) 

    Fig 3: Crimping Large Boot Clamps
    G04902012
  6. Install the cylinder tubes to the gear housing assembly.
  7. Install the lock nuts and outer sockets to the inner sockets.
  8. Thread the outer sockets onto the inner sockets to the specified length "L", then tighten the lock nuts to the specified torque. Refer to "DISASSEMBLY AND ASSEMBLY ". Reconfirm that the tie-rod length "L" is within specification.

    Maximum inner socket length "L" : 84.0 mm (3.31 in) 

    Fig 4: Adjusting Inner Socket To Standard Length L
    G04876915
scientia non olet · About LEMON Manuals