CVT Indicator Does Not Illuminate
- CHECK SEGMENT OF CVT INDICATOR
Perform self-diagnosis of combination meter. Refer to "OPERATION PROCEDURE ".
Are all segments displayed?
YES: GO TO 2.
NO: Replace combination meter. Refer to "COMBINATION METER ".
- CHECK COMBINATION METER (CONSULT-III)
- Connect CONSULT-III.
- Select "METER/M&A" on CONSULT-III, and perform self-diagnosis of combination meter. Refer to "CONSULT-III FUNCTION (METER/M & A) ".
Self-diagnostic results content
No malfunction detected: GO TO 3.
Malfunction detected: Check applicable parts, and repair or replace as necessary.
- CHECK COMBINATION METER INPUT SIGNAL
Use "DATA MONITOR" of "METER/M&A" on CONSULT-III. Confirm each indication on the monitor while operating the CVT selector lever.
SWITCH OPERATIONCONSULT-III display Switch operation Operation status P RANGE IND P range position ON Except for P range position OFF R RANGE IND R range position ON Except for R range position OFF N RANGE IND N range position ON Except for N range position OFF D RANGE IND D range position ON Except for D range position OFF L RANGE IND L range position ON Except for L range position OFF OK or NG
OK: Replace combination meter. Refer to "COMBINATION METER ".
NG: GO TO 4.
- CHECK SELF-DIAGNOSIS RESULTS OF TCM
Perform self-diagnosis of TCM. Refer to "CONSULT-III FUNCTION (TRANSMISSION) ".
OK or NG
OK: Check TCM input/output signal. Repair or replace malfunctioning part, if necessary. Refer to "TCM INPUT/OUTPUT SIGNAL REFERENCE VALUES ".
NG: Check applicable part, and repair or replace as necessary.