LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Sentra SE-R >> Repair and Diagnosis (Single Page) >> Engine Performance >> Engine Control Systems >> Engine Control System - DTCS P0447 To P0850 (Qr25DE) >> DTC P0453 EVAP Control System Pressure Sensor >> DTC Confirmation Procedure >> With GST

With GST

  1. Start engine and warm it up to normal operating temperature.
  2. Check that voltage between ECM terminal 95 (Fuel tank temperature sensor signal) and ground is less than 4.2V.
  3. Turn ignition switch OFF and wait at least 10 seconds.
  4. Wait at least 10 seconds.
  5. Select Service $07 with GST.

    If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

    Fig 1: Checking Voltage Between ECM Terminal 95 And Ground
    G04926085Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals