LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Rogue SL, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - DTCS P0506 To P2A00 (CALIFORNIA) >> P2004 Tumble Control Valve >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

  1. PRECONDITIONING

    If DTC CONFIRMATION PROCEDURE has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

    TESTING CONDITION: 

    • Before performing the following procedure, confirm that battery voltage is more than 11V at idle. 
    • Always perform the test at a temperature above 0°C (32°F) 

    GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE

    With CONSULT-III 

    1. Turn ignition switch ON.
    2. Select "DATA MONITOR" mode with CONSULT-III.
    3. Make sure that "COOLAN TEMP/S" indicates between 5°C (41°F) to 60°C (140°F).

      If not, cool engine down or warm engine up until "COOLAN TEMP/S" indicates between 5°C (41°F) to 60°C (140°F). Then go to the following steps.

    4. Fully release accelerator pedal and wait at least 5 seconds.
    5. Depress accelerator pedal and wait at least 5 seconds.
    6. Check 1st trip DTC.

    With GST 

    Following the procedure "With CONSULT-III" above.

    Is 1st trip DTC detected?

    YES: GO TO "DIAGNOSIS PROCEDURE ".

    NO: INSPECTION END

scientia non olet · About LEMON Manuals