Diagnosis Procedure
- CHECK OIL PRESSURE WARNING LAMP
- Start engine.
- Check oil pressure warning lamp and confirm it is not illuminated.
Is oil pressure warning lamp illuminated?
YES: GO TO "INSPECTION ".
NO: GO TO 2.
- CHECK INTAKE VALVE TIMING CONTROL SOLENOID VALVE
Refer to "COMPONENT INSPECTION ".
Is the inspection result normal?
YES: GO TO 3.
NO: Replace intake valve timing control solenoid valve.
- CHECK CRANKSHAFT POSITION SENSOR (POS)
Refer to "COMPONENT INSPECTION ".
Is the inspection result normal?
YES: GO TO 4.
NO: Replace crankshaft position sensor (POS).
- CHECK CAMSHAFT POSITION SENSOR (PHASE)
Refer to "COMPONENT INSPECTION ".
Is the inspection result normal?
YES: GO TO 5.
NO: Replace camshaft position sensor (PHASE).
- CHECK CAMSHAFT (INTAKE)
Check the following.
- Accumulation of debris to the signal plate of camshaft (1) rear end
- Chipping signal plate of camshaft rear end
Is the inspection result normal?
YES: GO TO 6.
NO: Remove debris and clean the signal plate of camshaft rear end or replace camshaft.
- CHECK TIMING CHAIN INSTALLATION
Check service records for any recent repairs that may cause timing chain misaligned.
Are there any service records that may cause timing chain misaligned?
YES: Check timing chain installation. Refer to "REMOVAL AND INSTALLATION ".
NO: GO TO 7.
- CHECK LUBRICATION CIRCUIT
Refer to "INSPECTION ".
Is the inspection result normal?
YES: GO TO 8.
NO: Clean lubrication line.
- CHECK INTERMITTENT INCIDENT
Refer to "INTERMITTENT INCIDENT ".
INSPECTION END