LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Rogue S, AWD >> Repair and Diagnosis >> Transmission >> Automatic Transmission >> Shift Position Indicator Circuit >> Overdrive Control Switch >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK CAN COMMUNICATION CIRCUIT

    Perform "SELF-DIAG RESULT" mode for "TRANSMISSION".

    Is "U1000 CAN COMM CIRCUIT" indicated?

    YES: Check CAN communication line. Refer to "DESCRIPTION ".

    NO: GO TO 2.

  2. CHECK COMBINATION METER

    Perform "SELF-DIAG RESULT" mode for "METER/M&A".

    Is the inspection result normal?

    YES: GO TO 3.

    NO: Check DTC detected item. Refer to "DTC INDEX ".

  3. CHECK OVERDRIVE CONTROL SWITCH
    1. Turn ignition switch OFF.
    2. Remove overdrive control switch. Refer to "WITHOUT MANUAL MODE : EXPLODED VIEW ".
    3. Check overdrive control switch. Refer to "COMPONENT INSPECTION (OVERDRIVE CONTROL SWITCH) ".

    Is the inspection result normal?

    YES: GO TO 4.

    NO: Repair or replace damaged parts.

  4. CHECK GROUND CIRCUIT (PART 1)

    Check continuity between control device vehicle side harness connector terminal and ground.

    CONTINUITY REFERENCE

    Control device vehicle side harness connector Ground Continuity
    Connector Terminal
    M57 2 Existed

    Is the inspection result normal?

    YES: GO TO 5.

    NO: Repair or replace damaged parts.

  5. CHECK GROUND CIRCUIT (PART 2)

    Check voltage between control device vehicle side harness connector terminal and ground.

    VOLTAGE SPECIFICATION

    Control device vehicle side harness connector Ground Voltage (Approx.)
    Connector Terminal
    M57 2 0 V

    Is the inspection result normal?

    YES: GO TO 6.

    NO: Repair or replace damaged parts.

  6. CHECK HARNESS BETWEEN CVT DEVICE AND COMBINATION METER (PART 1)
    1. Disconnect combination meter connector.
    2. Check continuity between control device vehicle side harness connector terminal and combination meter vehicle side harness connector terminal.
      CONTINUITY REFERENCE

      Control device vehicle side harness connector Combination meter vehicle side harness connector Continuity
      Connector Terminal Connector Terminal
      M57 1 M34 9 Existed

      Is the inspection result normal?

      YES: GO TO 7.

      NO: Repair or replace damaged parts.

    3. CHECK HARNESS BETWEEN CVT DEVICE AND COMBINATION METER (STEP 2)

      Check continuity between control device vehicle side harness connector terminal and ground.

      CONTINUITY REFERENCE

      Control device vehicle side harness connector Ground Continuity
      Connector Terminal
      M57 1 Not existed

    Is the inspection result normal?

    YES: GO TO 8.

    NO: Repair or replace damaged parts.

  7. DETECT MALFUNCTIONING ITEMS

    Check TCM connector pin terminals for damage or loose connection with harness connector.

    Is the inspection result normal?

    YES: Replace TCM. Refer to "EXPLODED VIEW ".

    NO: Repair or replace damaged parts.

scientia non olet · About LEMON Manuals