DTC Confirmation Procedure

CAUTION: Always drive vehicle at a safe speed.

NOTE: If "DTC CONFIRMATION PROCEDURE" has been previously performed, always turn ignition switch OFF. Then wait at least 10 seconds before performing the next test.

CHECK DTC DETECTION
With CONSULT-III
1. Turn ignition switch ON.
2. Select "DATA MONITOR".
3. Start engine and maintain the following conditions for at least 5 consecutive seconds.
  VEHICLE SPEED : 10 km/h (6 MPH) or more
  
  ACC PEDAL OPEN : More than 1.0/8
  
  RANGE : "D" position
  
  ENG SPEED : 450 rpm or more
  
  Driving location : Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test.
Is "P1723 CVT SPD SEN/FNCTN" detected?

YES: Go to "DIAGNOSIS PROCEDURE ".

NO: Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".