DTC Confirmation Procedure

CAUTION: Always drive vehicle at a safe speed.

NOTE: If "DTC CONFIRMATION PROCEDURE" has been previously performed, always turn ignition switch OFF. Then wait at least 10 seconds before performing the next test.

CHECK DTC DETECTION
With CONSULT-III
1. Turn ignition switch ON.
2. Select "DATA MONITOR".
3. Start engine and maintain the following conditions for at least 12 consecutive seconds.
  VEHICLE SPEED : 40 km/h (25 MPH) or more
  
  RANGE : "D" position
Is "P0841 PRESS SEN/FNCTN" detected?

YES: Go to "DIAGNOSIS PROCEDURE ".

NO: Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".