LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Quest SL >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - DTCS U1000 Through P0153 >> DTC P0117, P0118 ECT Sensor >> DTC Confirmation Procedure

DTC Confirmation Procedure

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.
  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-III.
  3. Wait at least 5 seconds.
  4. Check DTC.
  5. If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
    Fig 1: CONSULT-III Display - DATA MONITOR
    G04900036Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals