With Consult-III

TESTING CONDITION: 

Steps   4  and   7  may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle. 

1. Start engine (TCS switch or VDC switch OFF).
2. Select "DATA MONITOR" mode with CONSULT-III.
3. Press MAIN switch and make sure that CRUISE indictor lights up.
4. Drive the vehicle for at least 5 consecutive seconds under the following condition.
   VEHICLE SPEED CONDITION
   
   

   VHCL SPEED SE	More than 30 km/h (19 MPH)
   Shift lever	Suitable position

5. Check 1st trip DTC.
6. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

   If 1st trip DTC is not detected, go to the following step.

7. Drive the vehicle for at least 5 consecutive seconds under the following condition.
   VEHICLE SPEED CONDITION
   
   

   VHCL SPEED SE	More than 30 km/h (19 MPH)
   Shift lever	Suitable position
   Driving location	Depress the brake pedal for more than 5 seconds so as not to come off from the above-mentioned vehicle speed.

8. Check 1st trip DTC.
9. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".