LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Quest Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - DTCS U1000 Through P0153 >> DTC P0130, P0150 A/F Sensor 1 >> Overall Function Check >> With GST

With GST

  1. Start engine and warm it up to normal operating temperature.
  2. Drive the vehicle at a speed of 80 km/h (50 MPH) for a few minutes in the suitable gear position.
  3. Set D position with "OD" OFF, then release the accelerator pedal fully until the vehicle speed decreases to 50 km/h (30 MPH).
    NOTE: Never apply brake during releasing the accelerator pedal.
  4. Repeat steps  2 to  3 five times.
  5. Stop the vehicle and turn ignition switch OFF.
  6. Turn ignition switch ON.
  7. Wait at least 10 seconds and restart engine.
  8. Restart engine.
  9. Repeat steps  2 to  3 five times.
  10. Stop the vehicle and connect GST to the vehicle.
  11. Make sure that no DTC is displayed.

    If 1st trip DTC is displayed, go to "DIAGNOSTIC PROCEDURE ".