LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Pathfinder S, RWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - Component Testing (VQ40DE) >> ASCD Brake Switch >> Component Inspection >> Stop Lamp Switch

Stop Lamp Switch

  1. Turn ignition switch OFF.
  2. Disconnect stop lamp switch harness connector.
  3. Check harness continuity between stop lamp switch terminals 1 and 2 under the following conditions.
    CONTINUITY REFERENCE

    Condition Continuity
    When brake pedal: Fully released. Should not exist.
    When brake pedal: Slightly depressed. Should exist.
    Fig 1: Identifying Harness Continuity Between Stop Lamp Switch Terminals 1 And 2
    G04912068Courtesy of NISSAN MOTOR CO., U.S.A.

    If NG, adjust stop lamp switch installation, refer to "BRAKE PEDAL INSPECTION AND ADJUSTMENT ", and perform step  3 again.

scientia non olet · About LEMON Manuals