LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Frontier XE >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (Qr25DE) >> Component Diagnosis >> P0181 FTT Sensor >> DTC Confirmation Procedure

DTC Confirmation Procedure

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

With CONSULT-III

  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-III.
  3. Wait at least 10 seconds.

    If the result is NG, go to "DIAGNOSIS PROCEDURE ".

    If the result is OK, go to following step.

  4. Check "COOLAN TEMP/S" value.

    If the "COOLAN TEMP/S" is less than 60°C (140°F), the result will be OK.

    If the "COOLAN TEMP/S" is above 60°C (140°F), go to the following step.

  5. Cool engine down until "COOLAN TEMP/S" is less than 60°C (140°F).
  6. Wait at least 10 seconds.
  7. Check 1st trip DTC.
  8. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".

WITH GST

Follow the procedure "WITH CONSULT-III" above.

scientia non olet · About LEMON Manuals