LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2007 >> Xterra Off Road, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 474 (Engine Control System - Component Testing) >> ASCD Brake Switch >> Component Inspection >> Stop Lamp Switch

Stop Lamp Switch

WARNING: This page is about a different car, the 2007 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch OFF.
  2. Disconnect stop lamp switch harness connector.
  3. Check continuity between stop lamp switch terminals 3 and 4 under the following conditions.
    TERMINALS CONTINUITY CHART

    Condition Continuity
    Brake pedal: Fully released Should not exist
    Brake pedal: Slightly depressed Should exist

    If NG, adjust stop lamp switch installation, refer to , "BRAKE PEDAL ", and perform step  3 again.

    Fig 1: Checking Continuity Between Stop Lamp Switch Terminals 3 And 4
    G04920629Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals