With Consult-II
- Start engine (VDC switch OFF).
- Read "VHCL SPEED SE" in "DATA MONITOR" mode with CONSULT-II. The vehicle speed on CONSULT-II should exceed 10 km/h (6 MPH) when rotating wheels with suitable gear position.
If NG, go to "DIAGNOSTIC PROCEDURE ".
If OK, go to following step.
- Select "DATA MONITOR" mode with CONSULT-II.
- Warm engine up to normal operating temperature.
- Maintain the following conditions for at least 60 consecutive seconds.ENGINE SPEED CONDITION CHART
ENG SPEED 1, 550 - 6, 000 rpm (M/T)
1, 700 - 6, 000 rpm (A/T)COOLAN TEMP/S More than 70°C (158°F) B/FUEL SCHDL 5.5 - 31.8 msec (M/T)
6.3 - 31.8 msec (A/T)Selector lever Except Neutral position (M/T)
Except P or N position (A/T)PW/ST SIGNAL OFF - If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".