DTC P1128 Throttle Control Motor: Wiring Diagram

For PG-POWER, refer to POWER SUPPLY, GROUND & CIRCUIT ELEMENTS .

Fig 1: Wiring Diagram - EC-ETC3-01

Courtesy of NISSAN MOTOR CO., U.S.A.

Specification data are reference values and are measured between each terminal and ground. Pulse signal is measured by CONSULT-II.

CAUTION: Do not use ECM ground terminals when measuring input/output voltage. Doing so may result in damage to the ECM's transistor. Use a ground other than ECM terminals, such as the ground.

ITEM CONDITION CHART

TERMINAL NO.

WIRE COLOR

ITEM

CONDITION

DATA (DC Voltage)

Throttle control motor (Close)

[Ignition switch: ON]

Engine stopped
Shift lever: D (A/T), 1ST (M/T)
Accelerator pedal: Fully released

0 - 14V⁽¹⁾

Courtesy of NISSAN MOTOR CO., U.S.A.

Throttle control motor (Open)

[Ignition switch: ON]

Engine stopped
Shift lever: D (A/T), 1ST (M/T)
Accelerator pedal: Fully depressed

0 - 14V⁽¹⁾

Courtesy of NISSAN MOTOR CO., U.S.A.

⁽¹⁾	Average voltage for pulse signal (Actual pulse signal can be confirmed by oscilloscope.)