LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2007 >> X-Trail LE >> Repair and Diagnosis >> Transmission >> Transfer Case >> Trouble Diagnosis >> AWD Control Unit Input/Output Signal Reference Values >> AWD Control Unit Inspection Table >> Specifications with CONSULT-II

Specifications with CONSULT-II

CONSULT-II DISPLAY REFERENCE CHART

Monitor item [Unit] Content Condition Display value
FR RH SENSOR [km/h] or [mph] Wheel speed (Front wheel right) Vehicle stopped 0.00 km/h (0.00 mph)
Vehicle running
CAUTION: Check air pressure of tire under standard condition.
Approximately equal to the indication on speedometer (Inside of ±10%)
FR LH SENSOR [km/h] or [mph] Wheel speed (Front wheel left) Vehicle stopped 0.00 km/h (0.00 mph)
Vehicle running
CAUTION: Check air pressure of tire under standard condition.
Approximately equal to the indication on speedometer (Inside of ±10%)
RR RH SENSOR [km/h] or [mph] Wheel speed (Rear wheel right) Vehicle stopped 0.00 km/h (0.00 mph)
Vehicle running
CAUTION: Check air pressure of tire under standard condition.
Approximately equal to the indication on speedometer (Inside of ±10%)
RR LH SENSOR [km/h] or [mph] Wheel speed (Rear wheel left) Vehicle stopped 0.00 km/h (0.00 mph)
Vehicle running
CAUTION: Check air pressure of tire under standard condition.
Approximately equal to the indication on speedometer (Inside of ±10%)
BATTERY VOLT [V] Power supply voltage for AWD control unit Ignition switch: ON Battery voltage
THRTL POS SEN [%] Throttle opening condition When depressing accelerator pedal (Value rises gradually in response to throttle position.) 0 - 100%
ETS SOLENOID [A] Monitored value of current at AWD solenoid Engine speed : At idle 2WD Approx. 0.000A
AUTO Approx. 0.000A
LOCK Approx. 0.000A
Engine speed : 3, 000 rpm or more constant 2WD Approx. 0.000A
AUTO Approx. 0.000 - 1.500A(1)
LOCK Approx. 2.800A
STOP LAMP SW [ON/OFF] Condition of brake pedal operation Brake pedal: Depressed ON
Brake pedal: Released OFF
ENG SPEED SIG [RUN/STOP] Condition of engine running Engine stopped (Engine speed: Less than 400 rpm) STOP
Engine running (Engine speed: 400 rpm or more) RUN
ETS ACTUATOR [ON/OFF] Operating condition of AWD actuator relay (integrated in AWD control unit) Engine stopped (Ignition switch: ON) OFF
Engine running ON
4WD WARN LAMP [ON/OFF] AWD warning lamp condition AWD warning lamp: ON ON
AWD warning lamp: OFF OFF
4WD MODE SW [2WD/AUTO/LOCK] Input condition from AWD mode switch AWD mode switch 2WD 2WD
AUTO AUTO
LOCK LOCK
4WD MODE MON [2WD/AUTO/LOCK] Control status of AWD (Output condition of AWD indicator lamp and LOCK indicator lamp signal) AWD mode switch (Engine running) 2WD 2WD
AUTO AUTO
LOCK LOCK
DIS-TIRE MONI [mm] Improper size tire installed condition Vehicle running with normal size tire installed 0-4 mm
Vehicle running with improper size tire installed (Front/rear tire size difference, wear condition) 4-8 mm, 8- mm
P BRAKE SW [ON/OFF] Condition of parking brake Parking brake operated ON
Parking brake not operated OFF
(1) The values are changed by throttle opening and engine speed.