LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2007 >> X-Trail LE >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS U1000 To P0139 >> DTC P0138 Ho2S2 >> DTC Confirmation Procedure

DTC Confirmation Procedure

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

WITH CONSULT-II 

  1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.
  2. Start engine and warm it up to the normal operating temperature.
  3. Turn ignition switch OFF and wait at least 10 seconds.
  4. Start engine and keep the engine speed between 3, 500 and 4, 000 rpm for at least 1 minute under no load.
  5. Let engine idle for 2 minutes.
  6. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
Fig 1: Generic Scan Tool - Data Monitor
G06152489Courtesy of NISSAN MOTOR CO., U.S.A.

WITH GST 

Follow the procedure "WITH CONSULT-II" above.

scientia non olet · About LEMON Manuals