DTC Confirmation Procedure

CAUTION: Always drive at a safe speed.

NOTE:

If DTC P0011 is displayed with DTC P1111, first perform trouble diagnosis for DTC P1111. Refer to DTC P1111 IVT CONTROL SOLENOID VALVE .
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is between 10V and 16V at idle.

WITH CONSULT-II

Maintain the following conditions for at least 10 consecutive seconds.

Hold the accelerator pedal as steady as possible.

ENGINE SPEED REFERENCE

ENG SPEED	500 - 2, 000 rpm (A constant rotation is maintained.)
COOLAN TEMPS	60 - 120°C (158 - 248°F)
B/FUEL SCHDL	More than 7.26 msec
Shift lever	P or N (A/T), Neutral (M/T) position

Fig 1: Generic Scan Tool - Data Monitor

Courtesy of NISSAN MOTOR CO., U.S.A.

Let engine idle for 10 seconds.
If the 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
If the 1st trip DTC is not detected, go to next step.

Maintain the following conditions for at least 20 consecutive seconds.

ENGINE SPEED REFERENCE

ENG SPEED	1, 700 - 3, 175 rpm (A constant rotation is maintained.)
COOLAN TEMPS	70 - 105°C (158 - 221°F)
Shift lever	1st or 2nd position
Driving location uphill	Driving vehicle uphill (Increased engine load will help maintain the driving conditions required for this test.)

If the 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
WITH GST

Follow the procedure "WITH CONSULT-II" above.