Component Inspection

ACCELERATOR PEDAL POSITION SENSOR 

1. Reconnect all harness connectors disconnected.
2. Turn ignition switch ON.
3. Check voltage between ECM terminals 106 (APP sensor 1 signal), 98 (APP sensor 2 signal) and ground under the following conditions.
   VOLTAGE SPECIFICATION
   
   

   Terminal	Accelerator pedal	Voltage
   106 (Accelerator pedal position sensor 1)	Fully released	0.5 - 1.0V
   	Fully depressed	3.9 - 4.7V
   98 (Accelerator pedal position sensor 2)	Fully released	0.15 - 0.6V
   	Fully depressed	1.95 - 2.4V

   Fig 1: Checking Voltage Between ECM Terminals 106, 98 And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.
4. If NG, replace accelerator pedal assembly and go to the next step.
5. Perform "ACCELERATOR PEDAL RELEASED POSITION LEARNING ".
6. Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
7. Perform "IDLE AIR VOLUME LEARNING ".