DTC Confirmation Procedure
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
- If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
- Procedure for malfunction B is not described here. It takes extremely long time to complete procedure for malfunction B. By performing procedure for malfunction A, the incident that causes malfunction B can be detected.
TESTING CONDITION:
Steps 4 and 5 may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle.
WITH CONSULT-II
- Start engine.
- Select "DATA MONITOR" mode with CONSULT-II.
- Press CRUISE (MAIN) switch and make sure that CRUISE indicator lights up.
- Drive the vehicle for at least 5 consecutive seconds under the following condition.SHIFT LEVER REFERENCE
VHCL SPEED SE More than 30 km/h (19 MPH) Shift lever Suitable position If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
If 1st trip DTC is not detected, go to the following step.
- Drive the vehicle for at least 5 consecutive seconds under the following condition.SHIFT LEVER REFERENCE
VHCL SPEED SE More than 30 km/h (19 MPH) Shift lever Suitable position Driving location Depress the brake pedal for more than 5 seconds so as not to come off from the above-mentioned vehicle speed. - If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
WITH GST
Follow the procedure "WITH CONSULT-II" above.