DTC Confirmation Procedure

TESTING CONDITION: 

Always perform test at a temperature of 5°C (41°F) or more. 

WITH CONSULT-II 

1. Start engine and warm it up to normal operating temperature.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Turn ignition switch ON.
4. Select "DATA MONITOR" mode with CONSULT-II.
5. Make sure that "FUEL T/TEMP SE" is more than 0°C (32°F).
6. Wait at least 10 seconds.

   If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

Fig 1: Generic Scan Tool - Data Monitor

Courtesy of NISSAN MOTOR CO., U.S.A.

WITH GST 

1. Start engine and warm it up to normal operating temperature.
2. Check that voltage between ECM terminal 107 (Fuel tank temperature sensor signal) and ground is less than 4.2V.
   Fig 2: Checking Voltage Between ECM Terminal 107 And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.
3. Turn ignition switch OFF and wait at least 10 seconds.
4. Wait at least 10 seconds.
5. Select Service $07 with GST.

   If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".