LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2007 >> X-Trail LE >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0171 To P0453 >> DTC P0181 FTT Sensor >> DTC Confirmation Procedure

DTC Confirmation Procedure

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

WITH CONSULT-II 

  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-II.
  3. Wait at least 10 seconds.

    If the result is NG, go to "DIAGNOSTIC PROCEDURE ".

    If the result is OK, go to following step.

  4. Check "COOLAN TEMP/S" value.

    If the "COOLAN TEMP/S" is less than 60°C (140°F), the result will be OK.

    If the "COOLAN TEMP/S" is above 60°C (140°F), go to the following step.

  5. Cool engine down until "COOLAN TEMP/S" signal is less than 60°C (140°F).
  6. Wait at least 10 seconds.
  7. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
    Fig 1: Generic Scan Tool - Data Monitor
    G06152526Courtesy of NISSAN MOTOR CO., U.S.A.

    WITH GST 

    Follow the procedure "WITH CONSULT-II" above.

scientia non olet · About LEMON Manuals