LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2007 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Manual Transmission) >> RS6F94R >> Final Drive >> Disassembly and Assembly >> Assembly

Disassembly and Assembly: Assembly

WARNING: This page is about a different variant/trim than selected.
  1. Install pinion mate shaft, pinion mate gears, side gears and thrust washer into differential case.
  2. Install lock ring (1) onto differential case.
    CAUTION: Make sure that lock ring is securely installed in the groove.
  3. Install final gear into differential case, and tighten final gear bolts to specification. Refer to "FINAL DRIVE COMPONENTS ".
  4. Install speedometer drive gear onto differential case.
    Fig 1: Identifying Lock Ring From Differential Case
    G04926483
  5. Press-fit the differential side bearing inner race (clutch housing side) onto the differential case using a suitable tool (A).
    Fig 2: Identifying Differential Case With Suitable Tool
    G04926487
  6. Press-fit the differential side bearing inner race (transaxle case side) onto the differential case using a suitable tool (A).
    Fig 3: Identifying Transaxle Case Side
    G04926488
scientia non olet · About LEMON Manuals