LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2007 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Manual Transmission) >> RS6F52A >> Final Drive >> Disassembly and Assembly >> Disassembly

Disassembly and Assembly: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Remove final gear mounting bolts and then separate the final gear from differential case.
  2. Remove differential side bearing (clutch housing side) using the drift (A) [SST: ST33061000 (J-8107-2)] and pullers (B).
    CAUTION: Hook a puller on the cage of differential side bearing.
  3. Remove speedometer drive gear.
    Fig 1: Removing Differential Side Bearing (Clutch Housing Side) Using Drift
    G04889022
  4. Remove differential side bearing (transaxle case side) using the drift and pullers.
    CAUTION: Hook a puller on the inner race of differential side bearing.
    Fig 2: Removing Differential Side Bearing (Transaxle Case Side) Using Drift
    G04889023
  5. Remove retaining pin from differential case using a pin punch and then remove pinion mate shaft.
  6. Rotate pinion mate gears and remove pinion mate gears, pinion mate thrust washers, side gears, and side gear thrust washers from differential case.
    Fig 3: Identifying Lock Pin On Pinion Shaft
    G04889024
scientia non olet · About LEMON Manuals